The first thing that you might notice about these two rifles is the striking similarity in appearance. It should be similar because they are essentially the same in almost every feature except that one rifle is used by the army and the other one can be purchased at any reputed gun store.
Like the saying goes, the differences are only skin deep. For beginners, the receivers of the M14 are manufactured using what is known as the drop-forge technique. M1A on the other hand uses an investment cast receiver and may be comprised of a mixture of genuine United States GI military specification parts along with case replica parts, or simply all United States GI parts or even mostly investment cast parts along with smaller military specification parts. The sound created by the two receivers is different and any rifle audiophile can immediately differentiate the two by simply listening to their sound upon discharge.
The selector switch of M1As manufactured post 1990 are different from the ones on the M14. The M14 uses a walnut stock similar to the M21 that is height adjustable. Additionally, the 7.62mm caliber design was also dropped after the 1990 model of the M1A. M1As work only off 7.62x50mm NATO ammunition and not on anything else.
The bayonet lug has been removed from the newer M1A models. This was following the Assaults Weapons Ban of 1994 that prohibited the use of bayonet lugs on civilian weaponry. However, there is a workaround that allows owners to attached a bayonet lug to their M1As since the flash suppressor on the M1As are all identical.
When it comes to disassembly as well, there are minor differences between the two. With the M14, you can simply remove the connector and the operating rod slides out whereas the M1A uses a technique commonly known as “twist and pray” to remove the operating rod.
The M1A is strictly a semi automatic rifle. There is no way that it can be made to operate in a full automatic mode. The M14, on the other hand, is a selective fire military weapon. This translates into it being able to operate in selective automatic fire mode. The military initially hadthe selector switch to operate the M14 in full auto but eventually had it removed to a functionless knob since most of the soldiers were habitually leaving the selector to auto under all conditions. The M14 was infamous for not being very controllable in the auto mode and hence it was decided to drop the switch after a while. Thus, this is the reason why almost 90% of the M14s out there are forcibly semi auto with no option to switch.
The other big difference between the two weapons is the inflated price tag. The M14 is at least $14,000 dearer than the M1A. The high cost is attributed to the costlier fabrication process and the use of costlier military grade materials while making it. Hence, you need to be cautious and use discretion while handling the M14, especially if it is in the auto mode.
Do you know the number one reason of actually getting a bipod for your rifle? Shooters use bipods if they require fast setup speed and even better stability when it comes to shooting on unlevel ground. Achieving an accuracy below 1/2 moa with bipods requires a lot of care and consistency.
There are a number of reasons to why you would need a Harris Bipods on your M1A Rifle. For one, the bipods clamp securely and quickly to the M1A sling. It clamps to the gas block effectively since there isn't a better mounting point on an M1A. Harris Bipods are also equipped with strong recoil springs to prevent damage to the stock and maintain point of impact. Another thing to note on these Harris Bipods is the fact that their legs are adjustable for height.
The bipods come manufactured with heat treated steel and hard alloys and finished with a black anodized coat. Some of the models of under the Harris Bipods series are Model BR (Bench Rest) Lowest of the Bipods which is most useful for shooting off the bench. The bipods can be adjustable to a height from 6" to 9". Then there’s the Model L (Light). This model is the world's largest selling bipod as it is compact and light. It has an adjustable height from 9" to 13" and weighs 11 oz. Model H: (High) is for prone or sitting position shooting and it's the best for varmint shooting. The height is adjustable from 13 1/2" to 23". In the Model 25C, it is the tallest of the Bipods with the three piece leg construction being adjustable from 13 1/2" to 27"
There are several styles to choose from the Harris Bipods series. Series "M" is a new version of the original Leg Notch Bipod. This version is where the legs eject by spring action and its height is can be adjusted at a rate of 1" increments. The Series "S" features a rotating bipod that rotates to either side for instant leveling on uneven ground. Hinged base has tension adjustment and buffer springs to eliminate tremor or looseness. This model is similar to the non-rotating Series and is available for ALL models except the "H" model.
Harris Rifle Gun BiPod S-BRM 6-9 Inch With Swivel Leg Notch
Time Remaining: 25d 22h 36m
Buy It Now for only: $88.47
Harris ultralight bi pod
Time Remaining: 8h 4m
Harris Bipod 1A2-BR 6-9 Inch Solid Base 11206
Time Remaining: 2d 23h 16m
Buy It Now for only: $59.63
Harris Bipod 1A2-BRM 6-9 Inch Solid Base 11308
Time Remaining: 11d 2h 31m
Buy It Now for only: $59.29
Harris Bipod 1A2-L 9-13 Inch 11212
Time Remaining: 21d 3h 31m
Buy It Now for only: $64.89
Compact Modular Tactical Bipod- fits H&K,SIG,colt,5.56,308,Harris,EMA,atlas,NEW
Time Remaining: 14h 23m
Buy It Now for only: $69.99
Harris Series 1A2 Bipod Model LM 9-13" (Leg Notch)
Time Remaining: 11d 10h 4m
Buy It Now for only: $60.35
Harris Series 1A2 Bipod, Model 25C 13.5-27"
Time Remaining: 11d 9h 48m
Buy It Now for only: $73.63
Harris Engineering Rifle Gun Bipod SBRM 6-9" Swivel Leg Notch model
Time Remaining: 11h 2m
Buy It Now for only: $99.89